Exhaust flap control for Mercedes-AMG GT S Roadster – GG2 Fahrzeugtechnik

Abgasklappensteuerung für Mercedes-AMG GT S Roadster – GG2 Fahrzeugtechnik Abgasklappensteuerung für Mercedes-AMG GT S Roadster – GG2 Fahrzeugtechnik

Very high quality and easy to install exhaust flap control with remote control for Mercedes AMG GT

Mercedes AMG GT RX1 exhaust flap control

Mercedes AMG GT with two exhaust flaps.

AMG GT C190

AMG GTS C190

AMG GTC C190

AMG GTR C190

With this control unit you have the option of manually switching your exhaust flaps. The control is done using a hand-held transmitter. This gives you full control over your vehicle sound!

Advantages compared to competing products

Control independent of Drive Select

You decide on the vehicle sound and not the selected driving profile

Correct series mode (module deactivated) even after vehicle start

Important for visits to the workshop, service or TÜV.

Freely programmable start mode

You decide for yourself what sound you want to hear when you start your vehicle

No interference with the CAN bus

No danger to other control units

No influence of software updates on the function of our control

Plug and Play with original plugs

No damage to the original cables, no use of power thieves

The device offers the following modes:

start mode

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the last mode set and restores it when the vehicle is started. If you want a specific mode when starting, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired

Last state: Press the “Sport Mode” button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

assembly

Installation is plug and play. The device has vehicle-specific plugs that can be mounted directly on the exhaust flaps. We recommend installing it in the trunk for optimal reception and to avoid weather influences. The cables are designed to be long enough

Additional features

Can be retrofitted at any time without leaving any traces

No intervention in the standard CAN bus

No error message in the error log

handheld transmitter

High-quality and elegant appearance

brushed stainless steel front

High range

This device has been specially developed for use with electrical flap systems and therefore offers safe and long-lasting operation.

Rely on our quality! Brand product Made in Germany!